When to Replace Car Tyres: Tread, Cracks and Warning Signs

Table Of Contents:

  • When should you replace car tyres? The key signs in brief
  • How do you check tread depth using the TWI wear indicators?
  • What do tyre cracks and sidewall bulges mean?
  • What does the tyre wear pattern reveal?
  • How do Saudi heat and sand affect tyre life?
  • Should you replace tyres in pairs or all four together?
  • What about the spare tyre?
  • How do you choose the right replacement tyre: size, load and speed?
  • What is the tyre energy efficiency label in Saudi Arabia?
  • Frequently asked questions about replacing car tyres

If you are asking when to replace car tyres, the short answer is: replace a tyre when the surface of the tread reaches the level of the raised wear indicators inside the grooves, when a bulge, a deep cut or clear cracks appear in its sidewall, or when the rubber has aged to the point at which the tyre or car manufacturer recommends replacement, even if the tread looks good. In this guide we explain how to check your tyres, what the wear pattern reveals, and how to choose the right replacement.

When should you replace car tyres? The key signs in brief

Replacement is not tied to a single distance for every car, but to the tyre's condition and its maker's recommendations. The main signs are:

  • The tread surface has reached the level of the wear indicators in any part of the tyre, not just on average.
  • A bulge or bubble in the sidewall, a deep cut, or exposed cords or internal fabric.
  • Clear cracks in the sidewall or between the tread blocks, showing that the rubber has aged and hardened.
  • Uneven wear that has left part of the tyre smooth even though the rest of its surface is sound.
  • A persistent vibration that does not go away after balancing, or repeated pressure loss in the same tyre with no visible cause.

 

How do you check tread depth using the TWI wear indicators?

Inside the grooves are small raised bars called wear indicators, whose location is marked by the letters TWI or a small triangle on the tyre's shoulder, and when the tread surface is level with them, the tyre has reached the end of its usable life. To check:

  1. Park the car on level ground and turn the steering wheel to one side so you can see the front tyres clearly.
  2. Look for the TWI mark or triangle on the tyre's shoulder, then look into the groove next to it to find the raised bar.
  3. Compare the level of the tread surface with the bar; the closer they are to level, the closer the replacement date.
  4. Repeat the check on the inner edge, the centre and the outer edge, and at several points around the tyre's circumference.
  5. For a more precise reading, use a tread depth gauge, available at tyre shops, and record the reading for each tyre.
  6. Some drivers use a coin as a rough gauge, but it is no substitute for a proper gauge or a look by a qualified technician.

Do not wait until they are exactly level if you travel often or drive in the rain, as water clearance and grip weaken gradually as the tread gets shallower.

 

What do tyre cracks and sidewall bulges mean?

The sidewall flexes with every turn of the wheel and carries the car's weight, so any damage to it is more dangerous than tread wear:

  • Fine surface cracks: an early sign of rubber ageing caused by heat and sun, which calls for the tyre to be inspected by a specialist and monitored.
  • Deep cracks: if they widen or reach the tyre's inner layers, it is time to replace it.
  • A bulge or bubble: damage to the tyre's internal structure, usually after hitting a pothole or kerb, which requires immediate replacement and no travelling on it.
  • Cuts and gashes: a deep cut in the sidewall weakens the tyre even if no air is leaking from it yet.

 

What does the tyre wear pattern reveal?

The wear pattern reveals the cause of the problem, and if you do not fix it, new tyres will wear the same way:

Wear pattern Likely cause What to do
Both edges more than the centre Pressure lower than recommended Set the pressure according to the driver's door sticker and check it regularly
Centre more than the edges Pressure higher than recommended Set the recommended pressure, not the maximum pressure printed on the tyre
One inner or outer edge Wheel alignment or suspension fault Check the alignment and suspension parts
Diagonal, feather-like wear Incorrect toe between the two wheels Have the alignment set at an equipped workshop
Repeated patches or scallops Unbalanced wheels or worn shock absorbers Balance the wheels and check the shock absorbers
A single flat spot Hard braking with a locked wheel, or standing a long time without moving Have a specialist assess the tyre

If you see wear on both edges, start by reviewing the causes, signs and solutions for low tyre pressure, and if the wear is on one edge or comes with the car pulling to one side, read about the difference between wheel balancing and alignment.

 

How do Saudi heat and sand affect tyre life?

Rubber ages over time even if the car is used little, and you will find how to tell a tyre's age from the DOT code in our article on how to read tyre size and manufacture date. There is no single lifespan for all tyres, so refer to the tyre and car makers' recommendations. In the Kingdom's climate, some factors speed up deterioration:

  • Direct sun and high heat speed up the hardening and cracking of rubber, especially for cars standing for long periods in open car parks, so park in the shade whenever possible.
  • Hot asphalt raises tyre temperature, and the effect grows with low pressure or overloading on long trips.
  • Sandy, gravel and desert tracks expose the tread and sidewall to cuts from sharp stones, so inspect the tyres after every desert trip.
  • If you lower tyre pressure (deflating) to drive on sand, restore it to the recommended value before returning to asphalt, because highway driving at low pressure raises tyre temperature.

 

Should you replace tyres in pairs or all four together?

Ideally all four tyres match, but replacing them all together is not always necessary:

  • Replace both tyres on the same axle together at least, so grip does not differ between the two sides when braking or cornering.
  • When replacing only one pair, many tyre makers recommend fitting the newer pair on the rear axle for better stability, unless the owner's manual says otherwise.
  • In four-wheel-drive or all-wheel-drive cars, the owner's manual may require the four tyres to be close in size and degree of wear to protect the drive system, so check it before replacing only two.

 

What about the spare tyre?

The spare forgotten in the boot ages just like the other tyres, even if it is never used:

  • Check its pressure regularly and before every trip, because a flat spare will not help you when you get a puncture.
  • Read its manufacture date and inspect its sidewall, as it may be older than the tyres on the car.
  • A small temporary spare is designed for a limited distance and speed stated in the owner's manual or on the tyre's side, so use it only to reach the nearest tyre shop.
  • If your car comes with a repair kit instead of a spare, check its expiry and how to use it.

 

How do you choose the right replacement tyre: size, load and speed?

Choose what your car was designed for, not just what the shop has in stock, and check the following:

  1. Size: copy it from the sticker on the driver's door frame or from the owner's manual, not from the tyre currently fitted, which may be different.
  2. Load index and speed symbol: choose values equal to or higher than the car manufacturer's recommendation, never lower.
  3. Manufacture date: ask for recently made tyres with close dates, especially on the same axle.
  4. Type of use: a driver who often travels on highways has different needs from one who drives in the desert or carries heavy loads, so ask about the tyre designed for your use.
  5. Changing the size: do not change the size of your tyres or rims without consulting a specialist; to learn the effect, read our article on whether the wrong rims make your car use more fuel.
  6. After fitting: balance the wheels, set the pressure according to the driver's door sticker, and check the alignment if the old tyres were worn unevenly.

 

What is the tyre energy efficiency label in Saudi Arabia?

The Saudi Standards, Metrology and Quality Organization offers the Energy Efficiency Label for Tires service, and explains that the label serves as a guide for consumers before purchasing the product to increase their awareness of its energy efficiency before buying it.

The organization lists tyres among the products subject to the efficiency label regulations, and the aims of these labels include reducing energy consumption for the consumer, enabling the consumer to know a product's efficiency before buying, and protecting consumer safety and health and the environment. In practice:

  • When comparing tyres of the same size, ask to see the energy efficiency label for each one and read its details.
  • Do not make the label your only criterion; size, load index, speed symbol, manufacture date and the tyre's suitability for your use come first.
  • Requirements and procedures may be updated from time to time, so check the latest information on the organization's website.

 

Frequently asked questions about replacing car tyres

  1. Should I replace a tyre that is old even if its tread is good? Tread depth alone is not enough, as rubber hardens over time; have it checked by a specialist and follow the tyre maker's recommendation.
  2. Can a puncture in the side of the tyre be repaired? Repairing holes in the sidewall or shoulder is not usually recommended, while for a hole in the tread area the technician decides whether it can be repaired based on its size and position.
  3. Can I fit two tyres of different types? This is not recommended on the same axle, and it is best for all four tyres to match in type and tread pattern, especially in four-wheel-drive cars.
  4. Are small cracks between the tread blocks dangerous? They are a sign of ageing that may not require immediate replacement, but have a specialist monitor them, and if they deepen, replace the tyre.
  5. How often should I check my tyres? Check their pressure and appearance regularly, for example when refuelling, before every trip, and after hitting a pothole or kerb or after a desert trip.

 

Checking your tyres takes only minutes: look at the wear indicators, inspect the sidewall, notice the wear pattern and read the manufacture date. If a danger sign appears, do not postpone the change; choose a replacement with the recommended size, load and speed ratings, then fix the cause of any uneven wear.

FAQs

Related Blogs